Design preview · forms don’t send

Sapper HVAC Blog

Will a Mini Split Cool a Garage in 108 Degree Arizona Heat? A PebbleCreek Case Study

Yes. A correctly sized mini split holds an Arizona garage in the high 70s to low 80s when the outdoor temperature reaches 108. A PebbleCreek homeowner in Goodyear proved it with a 2 ton Daikin unit that Sapper HVAC installed for under $5,000.

  • Case Study
Contents · 9 sections
  1. What did the customer ask for?
  2. What equipment went in?
  3. How much does a garage mini split cost in Goodyear?
  4. What size mini split does an Arizona garage need?
  5. What did the installation day look like?
  6. What temperatures did the garage actually hold?
  7. Is a mini split worth it for an Arizona garage?
  8. Where does Sapper HVAC install garage mini splits?
  9. Frequently Asked Questions

August 15, 2026

7 min read

Quick Answer

Daikin 2 ton ductless mini split head mounted in a Goodyear Arizona garage

An uninsulated or lightly insulated Arizona garage runs 15 to 25 degrees above outdoor temperature by late afternoon. That puts a two car garage at 120 to 130 degrees on a 105 degree day, which makes the space unusable for anything but parking.

This post walks through a real job, a real bid, and real measured temperatures from a customer in the PebbleCreek community in Goodyear. You get the unit, the cost, the install day, and the numbers the garage held.

You will see the exact bid, the equipment that went in, and the temperatures the garage held against 108 degree heat. No theory, no square footage guesses, just a real install with real numbers from a real customer.

What did the customer ask for?

He wanted a mini split to bring the temperature down in his garage so he could use the space. He found Sapper HVAC through a referral posted in the PebbleCreek egroup and had already collected a bid from another HVAC company.

The PebbleCreek community in Goodyear has a large active adult population, and many residents use their garages for workshops, fitness rooms, and storage. A garage that hits 120 degrees limits all of that.

The competing bid came in at a number he called extravagant. Sapper HVAC returned his call the same day and quoted a 2 ton Daikin unit with full installation for under $5,000.

“my garage never got warmer than 80”

Dave R.

PebbleCreek, Goodyear AZ · Google Review

Read the full review on Google →

Dave found Sapper HVAC through a referral in the PebbleCreek egroup. He had a bid from another company that he found too expensive. Sapper HVAC quoted a 2 ton Daikin unit with full installation for under $5,000.

The crew arrived on time, completed the install in one day, and cleaned up the garage before they left. Dave got a walkthrough on the unit and the remote. He ran the unit overnight and the garage dropped to 77 degrees by morning. On a day that peaked at 108 outside, the garage never got warmer than 80 degrees.

What equipment went in?

A 2 ton Daikin ductless mini split, which is 24,000 BTU of cooling capacity. Sapper HVAC specs Daikin for garage work because the inverter compressor handles part load efficiency and holds tight temperature swings.

Daikin builds inverter driven compressors that ramp up to reach your setpoint fast, then drop to part load to hold it. That matters in a garage because the cooling load swings hard when the sun hits the west wall in the afternoon.

Sapper HVAC is an Daikin installer. The outdoor condenser plus indoor wall head arrangement needs no ductwork and no changes to the existing home system. The unit runs independent of your central AC, so you control it on its own thermostat.

The wall mounted indoor head sits high on the garage wall and distributes air across the space. The outdoor condenser sits on a pad outside. No ductwork means no cutting into ceilings and no conditioned air loss through leaky duct runs.

How much does a garage mini split cost in Goodyear?

This job came in under $5,000 for the 2 ton Daikin unit and full installation. Several variables move the number from job to job: garage square footage, ceiling height, insulation level, electrical panel capacity and the run to the disconnect, indoor head placement, and line set length.

A single car garage or a small workshop can land closer to $3,500 with a smaller unit. A three car garage or a space with heavy heat load can push past $6,000. The variables are real and they change the number.

Electrical work is the item that surprises people. A 2 ton mini split needs a dedicated 220 volt circuit. If your panel has room and the run to the disconnect is short, the electrical stays inexpensive. If the panel is full or the run is long, the cost goes up.

Sapper HVAC quotes a flat number after a site visit. The number on the estimate is the number on the invoice. See our beat any estimate guarantee. Pricing reflects August 2026. Current pricing comes from a free estimate.

What size mini split does an Arizona garage need?

Most two car garages in the Phoenix metro land between 18,000 and 24,000 BTU. Sapper HVAC sizes off a load calculation, not a square footage chart, because a garage is not a bedroom.

West facing walls, an uninsulated roll up door, a hot attic above, and a vehicle radiating stored heat all push the load up. Undersizing is the common failure. A unit too small for the space runs nonstop and still cannot hit your setpoint.

A 9,000 BTU unit works for a small bedroom. A garage is a different animal. The roll up door radiates heat. The slab absorbs cold all night and releases it slow. A car parked inside bleeds 130 degree sheet metal into the space for hours.

That is why Sapper HVAC runs a Manual J load calculation before quoting. The calculation accounts for wall exposure, insulation, window area, ceiling type, and the specific way you plan to use the space. See our sizing guide for the full breakdown.

What did the installation day look like?

One day, two technicians, on time arrival, and a clean garage at the end. The sequence goes: mount the indoor head, set the outdoor condenser on a pad, run and flare the line set, pull a vacuum, charge and commission, then test.

The line set connects the indoor head to the outdoor condenser. The crew flares the copper connections, pulls a deep vacuum to remove moisture and noncondensables, then releases the factory charge and tops off as needed.

A proper vacuum is the step that separates a 15 year install from a 5 year install. Moisture left in the system creates acid, and acid kills compressors. The crew walks you through the remote, the modes, and the setpoint before they leave. A unit the homeowner cannot operate is a unit that gets left off.

What temperatures did the garage actually hold?

77 degrees the morning after an overnight run, and a ceiling of 80 degrees on a day that peaked at 108 outside. A 28 degree pull against ambient in an Arizona garage is the difference between a space that is unusable in July and a space that works.

Dave set the unit to 76 degrees and let it run overnight. By 7 AM the garage read 77 degrees on a digital thermometer. The outdoor temperature that morning was 92 degrees.

By 4 PM that same day, the outdoor temperature peaked at 108. The garage held at 80 degrees with the unit running at part load. That is a 28 degree separation between the garage and the street, which turns a 120 degree oven into a workable shop, gym, or storage room.

Is a mini split worth it for an Arizona garage?

Yes for anyone who uses the garage for more than parking. The practical wins are protecting tools and paint and stored goods, a workable shop or gym, and a cooler wall between the garage and the living space.

Paint and finishes stored in a 120 degree garage degrade fast. Power tool batteries lose lifespan. Wine and food storage becomes impossible. A mini split protects all of it.

The honest tradeoff is that a garage mini split adds a load to the electric bill. A high efficiency inverter unit running at part load costs less to run than a window shaker or a portable unit doing the same job. See our garage mini split worth it post and our garage mini split page.

The wall between an attached garage and the living space also stays cooler, which takes a small load off your central AC. That is a secondary benefit, not the main reason to install one, but it counts.

Where does Sapper HVAC install garage mini splits?

Across the Phoenix metro including Goodyear, Gilbert, Chandler, Mesa, Phoenix, Surprise, Buckeye, Avondale, and Litchfield Park.

Frequently Asked Questions

Will a mini split cool a garage in Arizona when it is 108 outside?
How much does a garage mini split cost in Goodyear AZ?
What size mini split do I need for a two car garage in Arizona?
Do I need to insulate my garage before installing a mini split?
How long does a garage mini split installation take?
Will a garage mini split raise my APS or SRP bill?

Related Reading

Is a Mini Split Worth It for a Garage in Mesa?

Learn more →

Manual J Load Calculation in Arizona

Learn more →

Mini Split Installation in Goodyear

Learn more →

Get a flat price on your garage mini split

Free estimate. Same day callback. Veteran owned and Daikin authorized.

Need HVAC Help? Get a Free Quote from Sapper HVAC

Request HVAC Service or a Free Installation Quote

Need a repair? Start with our $149 service call. Planning a replacement or install? Estimates are free.

By submitting this form, you agree to our Privacy Policy and Terms & Conditions.

Yes, I agree to receive promotional texts and emails from Sapper HVAC. Consent is optional and not a condition of service. Message/data rates may apply. Reply STOP to opt out.

Licensed · ROC#360142 · Veteran-Owned · No spam, ever

RECENT POSTS

OUR SERVICES

HVAC Repair & Installation

Call Sapper HVAC Now

Mon to Fri 6 AM to 6 PM · Sat 6 AM to 12 PM

Veteran-owned · AZ ROC #360142

Repair, Replacement or New Installation?

Need a repair? Sapper HVAC services systems installed by any contractor with a $149 service call. Planning a replacement or new installation? Estimates are free.

Book a Comfort Specialist Tap to Call